Dubai Multi-puprose Engine Treatment

*******DUBAI*******

MULTI-PURPOSE ENGINE TREATMENT

Made in Korea

Introduction

            There are many metal treatments in the world and it supplies performance with lubricants, but its life is not maintained quite a long because its additive lose material properties and does not stick on the surface.

            Thus we developed new treatments to solve this problem which is very sticky on the surface.

            If it is mixed with any kinds of oil, it is activated as (-) ionic chemical coating and sticks on the surface and penetrates all porosity, and supplies less friction surface, and remains as slippery for a long time than others.

Performance

Adheres on the surface of metal strongly and reduces friction between piston and cylinder, bearing, crankshaft bearing, etc. This enables better engine operation, and engine noise. And also increases start-up speed. Normally 5% - 10% fuel consumption reduces.

Leaves its additive on the surface after engine stops, and when engine restarted, remarkable dry-start can be achieved any time regardless of weather.

Prevents sludge and carbon build-up from engine, oil can extend oil change cycle (250,000kms), prolong engine life, and reduces CO, HC gas, and soot smoke approximately 30% - 70% according to car condition.

It does not harm any engine parts like bearings, seals, valves and case. Instead it protects them from rust, corrosion and wear.

Can be used on new or any engine oil, lubricants, minerals or synthetics, because it is extracted from mineral oil and does not include any particles like PTFE resins (Teflon) or MoS, which can leave some hazard sludge.

Specific Formulation

Only P850.00 / 500ml bottle

 For single or bulk orders please contact:

 0926-7060892 (Globe) / 0910-6746414 (Smart)

 Mondays - Saturdays 9:00 AM to 5:00 PM

 Note: Price may vary depending on the volume of order

 Hurry, Limited stocks only.

 1 box inclusive of 12 500ml bottles

 only 8 boxes are available.