SAMANTHA 27

ADVANTAGE 27 “PRINCESS SAMANTHA 27”

SPECS AND FEATURES OF THE ADVANTAGE 27

Length:            27ft

Width:                        8ft 3in

Hull type: V hull entry which transforms to a concave form in the center portion of the hull. Good rough water Handling and quick to plane even with heavy load.

Construction: molded FRP Composite

Hull Reinforcement: Molded fiberglass cross-sectional frames minimum wood which consists of keel and transom. These components are sealed and encapsulated with fiberglass.

Floatation: closed cell non water absorbing foam placed under the floor and in gunnel cavities. Foam is not affected by gasoline or diesel fuels.

Mooning cleats: 6 SS cleats mounted forward mid ships and aft cleats are 12’ Gunnel impact protection, specially imported 3 in wide D-section rubber rub-rail which absorbs unusually strong impact from sides.

1. Large center helm console which houses a private toilet compartment. A manual flush household size marine toilet with vitreous china bowl is located within the compartment which is almost 5 ft. high an overhead light and exhaust blower are included within the compartment. Also includes a freshwater telephone shower in W.C. for use as bidet wash up.
2. Console includes compass w/ 3 in card, clear acrylic shielded recess for engine function gauges, lockable door to private toilet compartment, cigarette lighter 12 volt outlet lockable glove compartment.
3. Teleflex heavy duty hydraulic steering system with destroyer wheel.
4. Bait station mounted on aft of lean –to which includes sink , faucet , cutting board.
5. Bowsprit with anchor roller, rope and anchor. Penetrating anchor, G.I. chain and anchor line is included
6. Marine horn mounted under the bowsprit.
7. Transom platform with SS telescoping ladder.
8. A total of 85 gal fuel capacity in 2 fuel tanks.
9. 1100 GPH auto bilge pump. 2 one way bailers at transom for self bailing.

10. Aft anchor storage compartment and aft navy anchor with anchor line.

11. S.S. fully welded and polished tubular T-top made with 1 ¾” , 1 ½ “, 1 ¼” and 1” thick wall S.S. tube. Cover is made with red sunbrella material.

12. 5 rocket launchers mounted on the T-top aft section and B.S. rod holders mounted on the deck and railing. 2 forward railing mounted striker grip adjustable rod holders for bottom fishing.

13. Automatic salt water pumps for 2 bait wells. An automatic fresh water pump supplies the bidet shower and transom platform shower. Fresh water is pumped from a 15 gal tank.

14. 2 T-top mounted adjustable holders for outriggers

15. 2 forward deck mounted adjustable snap lock, power pedestal with 2 folding chairs.

16. Drink holders at various location

17. Tandem axle trailer with swivel jack , winch, tail lights and 2 fiberglass fenders.

18. 2 battery selector switch.

19. Brass shut off ball valves for both fuel lines.

20. Overhead storage compartment housing a DSC enabled VHF radio T-top mounted heavy duty ratchet base mount and 8ft fiberglass Shakespeare antenna.

21. Scuba tank holders aft.

22. 2 pairs of marine speakers

23. Australian made auto pilot

24. Foruno 1650 combination sonar/fish finder/GPS chart plotter. Electronic C-map of the Philippines is included.

25. Interphase UI twinscope color forward scanning (up to 12,000ft sonar)

26. Navman fuel management system.

27. 2X rocker stopper consisting of 4 stabilizers per side to lessen left to right motion while at rest.

28. Onboard U.S. made high quality battery charger.

29. Battery condition monitor mounted on dashboard.

30. 2 YAMAHA 115 HP outboard motors (10 hrs used on water total tach time 16 hrs)